Equipment – Thermostats – TS150W – Factory Reset
This article will guide you through troubleshooting a TS150W thermostat that is struggling to cool the HVAC zone.
Table of Contents
Factory Reset
- Locate the TS150W thermostat
- Reset the thermostat
- Diagnostics > Navigate to the right until you can select “Restart Device”
- When the device is restarted, go to the hamburger settings menu and choose “Setup”
- This is only available for a certain amount of time after resetting. If you cannot find it, reset the thermostat again.
- Go to Comms Settings.
- If the thermostat is connected to an EDGE's WiFi network, you won't see Factory Reset — you'll see Reset Network.
- Select Reset Network.
- After you Reset Network or if you're currently using RS-485, you'll see the Factory Reset option.
- Select Factory Reset.
What a Factory Reset does-
It will reset:
- units to Fahrenheit
- heat/cool setpoints to 69°/74°
- temp offset to 0 (i.e. adjustment that gets applied to sensor readings)
- comm timeout to 15 minutes
- provisioning mode to true (i.e. advertising its SSID, ready for wireless connection)
It will not alter:
- assigned modbus address
- hvac type / fuel type / valve type
- RS-485 vs. WiFi
- user-defined control strategy